Maniac Line Foam Gun PreWash Soap 1 Liter | 1000ml

Why, even if you wash the car by hand, personally and carefully wash after wash, you see micro-scratches and lines appear on the bodywork?
And when you empty the bucket, have you ever found dirt residues, such as soil at the bottom?

If the answer is YES, it means that no one has ever taught you the correct washing procedure: Let’s see it together:
Following the correct washing procedure, we start with cleaning rims and tires and their decontamination.

The next phase is the Pre-wash
it is carried out BEFORE proceeding with manual washing with shampoo.

PREWASH is the fundamental step that makes all the difference: we will in fact remove up to 80% of the coarse dirt present on the bodywork, without mechanical action, therefore without touching it.

Dirt particles firmly anchored to the bodywork, if you do not carry out a correct pre-wash, during manual washing will be transported by the glove or by the washing sponge with the risk of creating micro scratches (called “swirls” in the jargon) or worse deep scratches (called in jargon “rids”).

Only after having carried out a correct prewash can you proceed with manual washing in total safety. To learn more about the correct washing procedures, we invite you to watch the dedicated video.

Instructions for use

• It is recommended to use the product with a foam gun or cannon, but it is also excellent for pre-washing using a manual sprayer.
• Using a high-pressure foam cannon, in winter dilute the product with a ratio of 1:5 (1 part product in 5 parts water), for a final-output dilution ratio of around 1:50,
• Using a high-pressure foam cannon, in summer dilute with a ratio of 1:10 (1 part product in 10 parts water) a final-output dilution ratio of around 1:100.
• Spray a thick layer of foam on the vehicle and wait for it to run off (this may take up to 5 minutes).
• Rinse the vehicle from top to bottom.
• Using a low-pressure manual pump sprayer, in winter dilute with a ratio of 1:50 (1 part product in 50 parts water), 2 caps in 1 liter of water,
• Using a low-pressure manual pump sprayer, in summer with a ratio of 1:100 (1 part product to 100 parts water), 1 cap in 1 liter of water.
• Spray the product on the vehicle and wait 1 minute without letting the product dry on the bodywork, then rinse.